Page 1 of 1

Seats!

PostPosted: Sat Jan 22, 2011 9:38 am
by OneStepForward
Hi,

A couple of seat-related questions! We don't have a Stepwagon yet, so can't try it for ourselves!

- Can the front seats be used as part of the bed? ie. will they lie completely flat, and be more-or-less the same height as the middle seats, without overlapping them?

- Is it possible to tell from photos of the middle seats, taken from the sliding door, whether they're the turnaround type?

Ta muchly :)

Re: Seats!

PostPosted: Fri Jan 28, 2011 8:02 pm
by PARR
According to the handbook, the front seats will recline to add to the bed.

The middle seats which tip forward and slide are only two seats side by side - the rotating seats have a single bench and a small collapsible seat by the door - fairly obvious in photos.

Re: Seats!

PostPosted: Sat Jan 29, 2011 10:23 pm
by Vantastic
See this RF3 (2001-stepwagon for a view of the front seats when tipped back
Image

Image

The rear seats fold flattish - a good airbed ontop will minimise the bumps and seatbelt parts digging in! :lol:

Re: Seats!

PostPosted: Sun Jan 30, 2011 11:49 pm
by PARR
I thought that if the front seats were reclined in the fully forward position and the headrests removed, they flopped back into line with the 'turnaround' centre seats (1999 RF2) - the handbook shows that this should happen.

Re: Seats!

PostPosted: Fri Nov 16, 2012 7:02 pm
by Vantastic
^^^^^^ simon - another one to get rid of! ^^^^^^