Plastic roof trim

Plastic roof trim

Postby Scrap » Fri Oct 08, 2010 7:14 pm

Does anyone know how to remove the plastic roof trim (without breaking it)?

I'm having a problem with water getting inside my conversion and soaking the carpet & timber cupboard sides.

I can't see inside where it's getting in - I think it's behind the fitted cupboard & fridge.

I've ruled-out the pop-top as water's still getting in with the roof down and the rubber seal around the pop-top makes good contact with the roof.

Looking at the campervan roof, there's a gully where the trim meets the roof and the rubber seal between the two isn't continuous; there's a gap in it of about an inch into which rain water will drain. I'm thinking that somehow it's getting inside the van underneath the trim but I can't get it off to see. There's a bolt under each of the covers in the trim but it's still securely held after I remove them.

Any advice would be appreciated.

Regards

Brian
Scrap
 
Posts: 75
Joined: Sat Aug 15, 2009 3:27 pm

Re: Plastic roof trim

Postby PARR » Mon Jan 23, 2012 5:56 pm

Why not try a flexible silicone mastic sealer? It might stop the water coming in, and could be easily cut though and removed if someone eventually comes up with a better solution!
PARR
 
Posts: 270
Joined: Mon Nov 01, 2010 7:12 pm
Location: Cornwall near Eden Project and Fowey


Return to Body work

Who is online

Users browsing this forum: No registered users and 1 guest


cron